Industry

What to Document When Commissioning a New EOT Crane

0

Commissioning is the point where an overhead crane moves from installation to everyday use. That said, for a new or upgraded EOT crane, the records created at this stage become the reference for every inspection, repair and safety audit that follows. Gaps in documentation can make it harder to prove the crane was installed and tested correctly, to trace faults later or to plan maintenance with confidence. Organising the paperwork by stage helps make sure nothing important is missed.

Design and Supply Records

Remember, before the crane is installed, gather the documents that define what was ordered and supplied.

Specifications and Drawings

Record the rated capacity, span, lifting height, duty class, travel speeds and control type, along with general arrangement and electrical drawings. For upgrades, note exactly what was changed, such as a new hoist, increased capacity or updated controls, and keep the previous specifications for comparison.

Manufacturer Certificates

Collect test certificates for key components such as hoists, wire ropes, hooks and load chains, as well as material certificates for structural members where available. These confirm that parts meet the stated ratings and help match replacement parts in future. Serial numbers for the hoist, motors and control panel should also be listed so each unit can be identified quickly during servicing.

Installation Records

Installation records show that the crane was fitted to its supporting structure correctly.

Runway and Rail Alignment

Document surveys of the runway beams and rails, including span, straightness, level and rail joint gaps. Alignment problems can cause wheel wear and skewing, so recording measurements at handover provides a baseline for later checks. Including the date, the surveyor’s name and the instruments used makes the results easier to verify.

Structural and Electrical Connections

Note bolt sizes and tightening values at end carriages and girder connections, and keep records of electrical installation checks, including conductor systems, earthing, insulation tests and isolator positions. For upgraded cranes, record any changes to the supporting structure or power supply, along with confirmation that the building can carry the revised loads.

Testing Records

Testing confirms that the crane performs safely before it enters service. Records should capture the following:

  • No-load tests of all motions, including hoisting, cross travel and long travel.
  • Load tests carried out at the test loads required by the applicable standard or regulation, with results and any deflection measurements.
  • Brake performance during lifting, lowering and stopping under load.
  • Function checks of limit switches, overload protection, emergency stops and warning devices.
  • The names and qualifications of the persons conducting and witnessing each test.

Any defects found should be recorded together with the corrective action taken and the date of retesting. Photographs or short videos of key tests can also be attached as supporting evidence.

Handover Records

The final set of documents prepares the site team to operate and maintain the crane.

Manuals and Maintenance Schedules

Keep operating manuals, maintenance manuals, lubrication charts and recommended spare parts lists in an accessible place, both in print and digital form. The first scheduled inspection and service dates should be set at handover so that maintenance starts on time.

Training and Authorisation

Record which operators and maintenance staff received training on the crane, including dates and the topics covered. This helps confirm that only trained personnel are authorised to operate it, and shows when refresher training may be due.

Registration and Certification

Where local regulations require cranes to be registered or certified by an authorised examiner before use, file copies of these certificates alongside the commissioning records and note renewal dates.

A Record Trail Built for the Long Run

Thorough commissioning records cover design, supply, installation, testing and handover. Keeping them organised and accessible gives maintenance teams a clear baseline, supports future inspections and makes upgrades and audits easier to manage.

Speak with Shin Guan about commissioning records for your new or upgraded crane.

How Company Secretary Services Can Help Businesses Organise Corporate Records

Previous article

You may also like

Comments

Comments are closed.

More in Industry